MSL1000

Revision as of 10 December 2014 11:14 by JGoss (Comments | Contribs) | (→Interface Connector Pinouts)

The Opticon MSL1000 is a small form factor undecoded laser barcode scan engine. This low-profile scan engine is ideal for custom scanning applications including scanning non-standard barcodes. The MSL1000 is a fit for security systems, mobile devices, medical or diagnostic equipment or kiosks. This small form factor scan engine features a 650 nm visible laser diode that scans bi-directionally at a rate of 100 scans/second.


Interface Connector Pinouts

</tr>
caption 
 table code goes here
The table's caption
cell code goes here
next row cell code goes here next cell code goes here
Header 1 Header 2 Header 3
row 1, cell 1 row 1, cell 2 row 1, cell 3
row 2, cell 1 row 2, cell 2 row 2, cell 3


Interface Connector |-

| VCC | 1 | - | Power Supply: Typical: 3.3V |

LASER EN 2 I C-MOS Logic Level for Laser Control (ON/OFF: High = ON, Low = OFF) POWER EN 3 I C-MOS Logic Level for Power Supply (ON/OFF: High = ON, Low = OFF) SIGNAL 4 O C-MOS Logic Level for Logic Output of Bar Code Image: (High = Bars, Low = Spaces) TIMING 5 O C-MOS Logic Level for Synchronously-scanned Output: (High = Left to Right, Low = Right to Left) POLARITY 6 I C-MOS Logic Level for Selecting Signal Polarity: (High = Reversed Symbol, Low = Normal) Filter SEL 1 7 I C-MOS Logic Level for Selecting Analog Processing Filter Filter SEL 2 8 I SEL1/2 (00 = Standard Mode, 01 = Mode 1, 10 = Mode 2, 11 = Mode 3) TEST 9 I Set to Low or Open GND 10 - Ground

-|

Connector used was produced by KYOCERA ELCO Corp. Product No. 04 6238 010 010 883+ 10 PIN, 0.5mm Pitch, FCC Connector (Bottom Contact)