Version Differences for OPN-3102i - Opticon Technical Support Portal

Batch mode will be enabled when the device is no longer connected via bluetooth.

-

However, once reconnected, the data will begin streaming. It is recommended that you have a text editor or application open, assuming the OPN3102i is in BT-HID mode, so that the data has somewhere to go.

+

However, once reconnected, the data will begin streaming immediately. It is recommended that you have a text editor or application open, assuming the OPN3102 is in BT-HID mode, so that the data has somewhere to go.

+

To cause the OPN3102i to wait for a button press before streaming, scan [http://opticonfigure.opticon.com/sl/?z=1c1&a=4&b=2&d=1 this configuration sheet.]

To sever the Bluetooth connection, hold down the trigger/scan button until you hear a disconnect tone (or scan the "Manual Disconnect" scan code '+-DISC-+' - See the Universal Menu Book for the menu scan code symbols) -- This action just disconnects from the current Bluetooth host computer until it has something else to send.

* If in MFi mode, it will dump the data into the appropriate iOS application program.

 Batch mode will be enabled when the device is no longer connected via bluetooth.
-								However, once reconnected, the data will begin streaming. It is recommended that you have a text editor or application open, assuming the OPN3102i is in BT-HID mode, so that the data has somewhere to go.
+								However, once reconnected, the data will begin streaming immediately. It is recommended that you have a text editor or application open, assuming the OPN3102 is in BT-HID mode, so that the data has somewhere to go.
 								To cause the OPN3102i to wait for a button press before streaming, scan [http://opticonfigure.opticon.com/sl/?z=1c1&a=4&b=2&d=1 this configuration sheet.]
 To sever the Bluetooth connection, hold down the trigger/scan button until you hear a disconnect tone (or scan the "Manual Disconnect" scan code '+-DISC-+' - See the Universal Menu Book for the menu scan code symbols) -- This action just disconnects from the current Bluetooth host computer until it has something else to send.
 * If in MFi mode, it will dump the data into the appropriate iOS application program.