| |
# Download the Firmware: OS, and Appload for this process available in the [[#Software|Software Downloads]] section. You may also need Opticon's [[#Drivers|USB Drivers]], so please download those as well. |
|
# Download the Firmware: OS, and Appload for this process available in the [[#Software|Software Downloads]] section. You may also need Opticon's [[#Drivers|USB Drivers]], so please download those as well. |
| - |
# Extract the OPN-3002i OS zip file, the Appload.zip file, and the the USB Drivers Installer.zip file - Files into a convenient folder.
|
+ |
# Extract the OPN-3002i OS zip file, the Appload.zip file, and the USB Drivers Installer.zip file - Files into a convenient folder.
|
| |
# Install the USB Drivers Installer by double-clicking the USB Drivers Installer.exe, which will start the install wizard. The default settings for the installer are fine in most cases so press Install, then ok until you are finished. |
|
# Install the USB Drivers Installer by double-clicking the USB Drivers Installer.exe, which will start the install wizard. The default settings for the installer are fine in most cases so press Install, then ok until you are finished. |
| |
# Install [[Appload]] by double-clicking the 'Appload Setup.exe' file, which will start the install wizard. The defaults are fine in most cases, so keep clicking 'Next' until you are finished. Appload will launch at the end of the install process. |
|
# Install [[Appload]] by double-clicking the 'Appload Setup.exe' file, which will start the install wizard. The defaults are fine in most cases, so keep clicking 'Next' until you are finished. Appload will launch at the end of the install process. |
| - |
# Connect the OPN2006 to your PC
|
+ |
# On the Quickstart guide available in the [[#Documents|Document Downloads]] section. Scan the 'Bluetooth' - 'SPP' barcode followed by the 'USB Data' - 'Enable' to allow USB communications in the scanner
|
| |
|
+ |
# Connect the OPN3002i to your PC
|
| |
===Install the Firmware=== |
|
===Install the Firmware=== |
| |
# Launch Appload if it is not already running. |
|
# Launch Appload if it is not already running. |
