| |
Select 'File' > 'Download' from the Appload menu and browse to the firmware file you wish to load. Note that if you must upgrade the OS as well as an Application you will need to set up the OPH1004 a second time as well. |
|
Select 'File' > 'Download' from the Appload menu and browse to the firmware file you wish to load. Note that if you must upgrade the OS as well as an Application you will need to set up the OPH1004 a second time as well. |
| |
|
+ |
The OPH1004 has an RTC (Real Time Clock) that can keep track of the time and date. However, since the device does not support Daylight Savings Time it may be necessary from time to time to reset the stored date and time. This can be accomplished two ways. The first way is using the PC program Appload very similarly to loading firmware (described above). The second us manually on the unit itself.
|
| |
|
+ |
* Download and Install Appload and Cradle Drivers for the OPH1004's cradle, the CRD1001. Both are available on the downloads section on this page.
|
| |
|
+ |
* Connect the cradle to the PC and external power (even if you use USB you must also use the supplied AC adapter).
|
| |
|
+ |
* In Appload select 'Settings' > 'Port' and choose the line similar to 'Opticon OPL/CRD USB Serial Port'.
|
| |
|
+ |
* In Appload select 'Settings' > 'IrDA Adapter/Cradle type' and choose 'Tekram compatible'
|
| |
|
+ |
* In Appload select 'Utilities' > 'Send time'. It will only take a few seconds. You will see a, 'ok' popup message in Appload and the OPH1004 will restart.
|
| |
|
+ |
* Install a charged battery in the OPH1004.
|
| |
|
+ |
* Start with the OPH1004 powered OFF.
|
| |
|
+ |
* hold [.] and [1] and press [POWER]. You should boot into 'SYSTEM MENU'. If not, power off the unit and try again.
|
| |
|
+ |
* Use the UP and DOWN (Q1 and Q2 respectively) buttons to move the cursor to different parts of the time and date.
|
| |
|
+ |
** Special Note: Currently you cannot actually see the cursor when it is on one of the date or time fields and it can only be seen when it is over the Cancel or OK buttons. It will take some practice to get this method correct due to this limitation.
|
| |
|
+ |
** Second note: When navigating around the date and time the cursor will skip the first two fields of the year. I.e. 2011 is the year and the cursor will skip the 20 and jump directly to the last two digits.
|
| |
|
+ |
* If you make any mistakes simply press the UP or DOWN arrow to go back to where you were and try again. When you type a new value note that the cursor will automatically advance to the next field.
|
