Version Differences for H13 - Opticon Technical Support Portal

This version of Speedgen comes with a detailed help file rather than a manual. So if you get stuck trying to figure out how to configure your build file then please consult the help file. If you have a specific question or would like some general guidance you are always welcome to write [mailto:support@opticonusa.com Opticon Technical Support]. We can't make the application for you but we are always willing to help.

+

==Set the Time==

+

===Appload===

+

# [[#Install_Drivers_and_Appload|Install Drivers and Appload]]

+

# In Appload [[#Select_COM_port|Set COM Port]]

+

# In Appload select Utilites > Send time

+

===On Device===

+

# Install a charged battery in the H13.

+

# Start with the H13 powered OFF.

+

# Hold [.] and [1] and press [POWER]. You should boot into 'SYSTEM MENU'. If not, power off the unit and try again.

+

# Select 'Settings'

+

# Select 'Time & Date'

+

# Use the UP and DOWN (Q1 and Q2 respectively) buttons to move the cursor to different parts of the time and date.

+

## Special Note: Currently you cannot actually see the cursor when it is on one of the date or time fields and it can only be seen when it is over the Cancel or OK buttons. It will take some practice to get this method correct due to this limitation.

+

## Second note: When navigating around the date and time the cursor will skip the first two fields of the year. I.e. 2011 is the year and the cursor will skip the 20 and jump directly to the last two digits.

+

If you make any mistakes simply press the UP or DOWN arrow to go back to where you were and try again. When you type a new value note that the cursor will automatically advance to the next field.

==Downloads==

 This version of Speedgen comes with a detailed help file rather than a manual.  So if you get stuck trying to figure out how to configure your build file then please consult the help file.  If you have a specific question or would like some general guidance you are always welcome to write [mailto:support@opticonusa.com Opticon Technical Support].  We can't make the application for you but we are always willing to help.
 								==Set the Time==
 								===Appload===
 								# [[#Install_Drivers_and_Appload|Install Drivers and Appload]]
 								# In Appload [[#Select_COM_port|Set COM Port]]
 								# In Appload select Utilites > Send time
 								===On Device===
 								# Install a charged battery in the H13.
 								# Start with the H13 powered OFF.
 								# Hold [.] and [1] and press [POWER]. You should boot into 'SYSTEM MENU'. If not, power off the unit and try again.
 								# Select 'Settings'
 								# Select 'Time & Date'
 								# Use the UP and DOWN (Q1 and Q2 respectively) buttons to move the cursor to different parts of the time and date.
 								## Special Note: Currently you cannot actually see the cursor when it is on one of the date or time fields and it can only be seen when it is over the Cancel or OK buttons. It will take some practice to  get this method correct due to this limitation.
 								## Second note: When navigating around the date and time the cursor will skip the first two fields of the year. I.e. 2011 is the year and the cursor will skip the 20 and jump directly to the last two digits.
 								If you make any mistakes simply press the UP or DOWN arrow to go back to where you were and try again. When you type a new value note that the cursor will automatically advance to the next field.
 ==Downloads==