| Line 14: |
| |
===Setting Up the Host=== |
|
===Setting Up the Host=== |
| |
To use NetO communications on a PC you need an application called NetO32. This can be downloaded from the Downloads table at the bottom of this page. Simply run the installer after download is complete and follow the setup instructions here. |
|
To use NetO communications on a PC you need an application called NetO32. This can be downloaded from the Downloads table at the bottom of this page. Simply run the installer after download is complete and follow the setup instructions here. |
| |
|
+ |
====Collect Materials====
|
| |
|
+ |
* A windows computer
|
| |
|
+ |
* An H13
|
| |
|
+ |
* A CRD13 cradle
|
| |
|
+ |
* A 32-00606-00 power adapter for the CRD13
|
| |
|
+ |
* Either a USB-A to USB-B cable or an Opticon RS232 cable
|
| |
|
+ |
====Assembly====
|
| |
|
+ |
# Connect the 32-00606-00 power adapter to a power outlet.
|
| |
|
+ |
# Connect the 32-00606-00 power adapter to the CRD13.
|
| |
|
+ |
# Connect the communication cable to the computer.
|
| |
|
|
|
| |
|
+ |
* If using USB then you can plug the USB cable in to any active USB port on the computer.
|
| |
|
+ |
* If using RS232 your computer must have a DB9 (nine pin RS232) connector on the back.
|
| |
|
|
|
| |
|
+ |
===Software Installation===
|
| |
|
+ |
In this section we step through installing both Opticon's USB drivers and NetO32.
|
| |
|
+ |
====Installing USB Drivers====
|
| |
|
+ |
If you are using RS232 please skip to Installing NetO32. Opticon's USB drivers need to be installed for the cradle to be properly via USB.
|
| |
|
+ |
# Download the USB drivers by clicking here .
|
| |
|
+ |
# Open the zip file by double clicking on it.
|
| |
|
+ |
# Launch the installer by double clicking on it.
|
| |
|
+ |
# Follow the prompts to finish the installation.
|
| |
|
+ |
====Installing NetO32====
|
| |
|
+ |
The H13 uses a piece of windows software called NetO32 to save the data file to the computer. To install NetO32 follow the steps below.
|
| |
|
+ |
# Download NetO32 by clicking here .
|
| |
|
+ |
# Open the zip file by double clicking on it.
|
| |
|
+ |
# Launch the installer by double clicking on it.
|
| |
|
+ |
# Follow the prompts to finish the installation.
|
| |
|
|
|
| |
|
+ |
===Configuration===
|
| |
|
|
|
| |
* Select 'Tools' > 'Options' |
|
* Select 'Tools' > 'Options' |
| |
** Choose RS232 from the menu at left |
|
** Choose RS232 from the menu at left |
