| |
* When changing the type of interface to be used, be sure to turn off the power, change the setting of the scanner's connection destination, and read the BD address. It may cause malfunctions such as incorrect connection or failure to send the barcode data correctly to the host. |
|
* When changing the type of interface to be used, be sure to turn off the power, change the setting of the scanner's connection destination, and read the BD address. It may cause malfunctions such as incorrect connection or failure to send the barcode data correctly to the host. |
| |
|
+ |
Follow the directions below to load firmware on to the CRD-3301B.
|
| |
|
+ |
# Download the Firmware: OS, and Appload for this process available in the [[#Software|Software Downloads]] section. You may also need Opticon's [[#Drivers|USB Drivers]], so please download those as well.
|
| |
|
+ |
# Extract the CRD-3301B OS zip file, the Appload.zip file, and the USB Drivers Installer.zip file.
|
| |
|
+ |
# Install the USB Drivers Installer by double-clicking the USB Drivers Installer.exe, which will start the install wizard. The default settings for the installer are fine in most cases so press Install, then ok until you are finished.
|
| |
|
+ |
# Install [[Appload]] by double-clicking the 'Appload Setup.exe' file, which will start the install wizard. The defaults are fine in most cases, so keep clicking 'Next' until you are finished. Appload will launch at the end of the install process.
|
| |
|
+ |
# Connect the CRD-3301B to your PC via the USB cable and make sure the power adaptor is plugged in as well.
|
| |
|
+ |
===Install the Firmware===
|
| |
|
+ |
# Launch Appload if it is not already running.
|
| |
|
+ |
# We first need to choose the correct COM port. From the main Appload window, select 'Settings' > 'Port', then choose the port that says 'Opticon OPL/CRD USB Serial Port'.
|
| |
|
+ |
# Now we can start downloading the OS. For the Firmware: OS you downloaded and extracted above, please choose 'File', then 'Download', then navigate to and select the file. You should see a progress indicator and the words 'Initializing IRdA' if this is working.
|
| |
|
+ |
# When complete Appload will prompt you with a download complete message. When you see this message, the process is complete.
|
