CRD3301

Revision as of 19 October 2017 15:58 by JGoss (Comments | Contribs) | (→DIP SWITCHES)

About

The CRD3301 is a charging and communication cradle for the OPR3301, OPI3301, and OPI-3301i .

Note

The cradle must be rebooted before new dip switch settings can take effect.

DIP SWITCHES

Setting of DIPSW The following functions can be set with DIPSW on the bottom of this unit.

  • DIPSW 1: Always be sure to turn OFF.

It is for future function expansion.

  • DIPSW 2: No security, inquiry scan enabled.

You will be able to connect without authentication.

  • DIPSW 3: Invalidate the connection protocol.

It will be able to connect with Bluetooth devices other than OPR - 3101.

  • DIPSW 4: Disables detection of the DTR signal of the host.

Set when there is no DTR signal on the host side equipment.

  • DIPSW 5: Set to the initial state (shipping setting).

The contents of FLASH are returned to the initial state.

  • DIPSW 6: Please use it normally OFF.

In the ON state, the unit enters a download mode (software rewrite mode is set). Software can be changed using the RS - 232C interface.

  • All DIP-SWITCHES are read at power-on. If any are changed, the unit must power-cycle.