The PX-100 is a 1D CCD mobile barcode scanner that utilizes a smartphone or tablet to scan barcodes. The PX-100 uses the PX-100 mobile application to scan barcodes and configure the scanner to control readability options as well as the prefix and suffix.

Initial Setup:

To Use on iOS:

1. Download the iOS application PX-100 Terminal from the App Store on your device.
2. Launch the PX-100 Terminal application.
3. Plug the 3.5mm audio jack into the headphone port on the device.
4. Press "OK".

To Use on Android:

1. Download the Android application PX-100 Terminal from the Google Play Store Located here:
2. Launch the PX-100 Terminal application.
3. Plug the 3.5mm audio jack into the headphone port on the device.
4. Press "OK".

Configuration Settings:

The PX-100 can have a variety of configuration settings such as:

• Adding up to 4 characters in the Prefix
• Adding up to 4 characters in the Suffix
• Barcode Options
• Readability of Barcodes
• Buzzer Settings
• Vibrate settings

Charging:

To charge the PX-100, plug the micro usb cable into the micro usb port. The charge indicator will turn RED while it's charging. When the RED indicator disappears the device is fully charged.

Firmware Loading:

Follow the directions below to load firmware on to the PX-100:

Preparation

1. Download the Firmware: OS, and Appload for this process available in the Software Downloads section. You may also need Opticon's USB Drivers, so please download those as well.
2. Extract the PX-100 OS zip file, the Appload.zip file, and the USB Drivers Installer.zip file into a convenient folder.
3. Install the USB Drivers Installer by double-clicking the USB Drivers Installer.exe, which will start the install wizard. The default settings for the installer are fine in most cases so press Install, then ok until you are finished.
4. Install Appload by double-clicking the 'Appload Setup.exe' file, which will start the install wizard. The defaults are fine in most cases, so keep clicking 'Next' until you are finished. Appload will launch at the end of the install process.
5. Connect the PX-100 to your PC

Install the Firmware

1. Launch Appload if it is not already running.
2. We first need to choose the correct COM port. From the main Appload window, select 'Settings' > 'Port', then choose the port that says 'Opticon USB Code Reader'.
3. Now we can start downloading the OS. For the Firmware: OS you downloaded and extracted above, please choose 'File', then 'Download', then navigate to and select the file. You should see a progress indicator and the words 'Initializing IRdA' if this is working.
4. When complete there will be a "Download Complete" window that pops up in Appload. Press okay and remove the PX-100 from the computer.

Downloads

Documents

Software

Drivers