PHL8xxx

Summary

It runs Windows CE 5.0. The PHL 8000s series feature an integrated 1D engine and a full 3.5" TFT display, a numeric or aphanumeric (full ) keypad. The PHL 8000 meets IP 54 standards. The unit unit comes with a 2000mAh battery pack or can use the optional 4000mAh high capacity battery.

Communications

• The PHL8000 will utilize the Summit MCF10G CCX v4 WLAN module. W-LAN 802.11 b/g
• Bluetooth communication (Class II)
• GSM/GPRS: optionally built in GSM/GPRS/EDGE module, quad band.

Part Number Format

PHL-8xyz

Cradle

The cradle for the PHL-8000 is the IRU8000

Warm Reboot

With the stylus press the reset switch on the back of the unit.

Cold Boot

While holding the power button: use the stylus to press the reset switch on the back of the unit.

SD Card Compatibility

The PHL-8000 is known to work with at least 16GB SDHC cards (tested with Kingston 16GB microSD card with adapter).

Scanner Firmware Upgrade

The barcode scanner inside the PHL8xxx runs its own firmware independent of that running Windows. Consequently this firmware can be upgraded should it become necessary.

• Download the latest firmware for your device from the Downloads table below.
  • For PHL-8xx2 devices (Except PHL8152), download the image in the name format C01-­53.XX-­EFA2-­YYYY where xx is the latest version number.
  • For PHL-8xx4 devices and the PHL8152, download the image in the name format C01-­54.XX-­EFA3-­YYYY where xx is the latest version number.
• Unzip and copy the firmware file to the PHL-8112 either via SD card or over an ActiveSync (or Windows Mobile Device Center) connection. If you use an SD card ensure you use FAT format on an SD card with capacity no greater than 2GB. HC SD cards are not supported.
• Double-tap the barcode icon at the bottom of the screen.
• Tap the 'Firmware Upgrade' tab
• Tap 'Open' and browse to the firmware file you have copied to the device.
• Tap 'Upgrade'. Select 'Yes' when prompted.
• The process is complete when you see the message 'Firmware update completed'.
  • Notes: This same process can be used to downgrade the firmware as well as upgrade. Simply select the appropriate firmware file.
  • A battery with at least 30% charge must be installed.
  • Both swivel locks must be locked.

Models and Options

PHL8112 W-LAN, Bluetooth, 1D barcode scanner, numeric keypad

PHL8114 W-LAN, Bluetooth, 1D barcode scanner, numeric keypad, GSM/GPRS/EDGE

PHL8212 W-LAN, Bluetooth, 1D barcode scanner, alphanumeric keypad

PHL8214 W-LAN, Bluetooth, 1D barcode scanner, alphanumeric keypad, GSM/GPRS/EDGE

Downloads

Documents

Software