PHL8000

Revision as of 02 November 2010 16:47 by jschurr (Comments | Contribs) | (Added content from original page) n

Backup & Restore

Backup

To create a backup of your PHL-8000 follow the steps below.

  • Navigate to: 'Start' > 'Settings' > 'Control Panel' > 'Control Center' (icon) > 'Backup & Restore' (icon)
  • Choose Backup Location (DiskOnChip or SD Card)
  • click 'Backup Now'
  • click 'Yes' when prompted
  • You will see the following text on the screen:
Backup the system
Please wait..
Note: only one backup can exist at a time

Restore

To restore a previously created backup follow the steps below.

  • Navigate to: 'Start' > 'Settings' > 'Control Panel' > 'Control Center' (icon) > 'Backup & Restore' (icon)
  • Choose the location of the Backup (DiskOnChip or SD Card)
  • click 'Restore Now'
  • click 'Yes' when prompted
  • You will see the following text on the screen while the restore is in progress:
Restore the system
Please wait..
  • When complete you will see the following message:
System is restored
Please reset system
(warm boot)
  • Perform a Warm boot using the 'reset' switch on the back of the unit (stylus required)