H22

About the H22

The H22 is Opticon's newest Windows Mobile Terminal. The main features of H22 are:

• Windows Mobile 6.5.3 operating system
• HSDPA/HSUPA 7.2Mbps/2.0Mbps cellular connection
• 3.7" transflective VGA display with touch window
• Available with qwerty or numeric keyboard

Accessories

• Single slot USB cradle
• 4 slot multicradle with Ethernet support
• Pistol grip
• Battery BTR0600 - LBP-02 (same as H21)

Technical details

• Windows Mobile 6.5.3 operating system
• IP65 rating
• Marvell PXA320@806MHz processor with 256MB/512MB RAM/Flash
• UMTS 800/850/1900/2100MHz
• GSM/GPRS/EDGE 850/900/1800/1900MHz
• HSDPA/HSUPA 7.2Mbps/2.0Mbps
• 3.7" transflective VGA display with touch screen
• Available with qwerty or numerical keyboard
• aGPS
• Bluetooth 2.0 + EDR
• WLAN 802.11bgn with CCXv4
• 3.2Mpix autofocus camera
• 1D or 2D barcode scanner
• 3.5mm audio connector
• micro AB USB connector
• Cradle connector
• IrDA
• Accelerometer
• Ambient Light Sensor
• Proximity Sensor
• Optional RFID HF
• SAM slot (Smart Card slot)
• MicroSD card slot

Key Combinations

• Checksum:BR1 + BR2 + Vol_UP
• Factory Reset:BR1 + BR2 + Power Button
• SD update IPL: Vol_UP + Vol_DN
• SD update EBOOT: BR1 + Vol_DN
• SD update OS: BR1 + Vol_UP
• SD update IPL+EBOOT+OS: BR1 + BR2 + Vol_DN
• SA-DIAG: BR2 + Vol_DN

Legend:

• BR1 = Left scan button
• BR2 = Right Scan Button
• Vol_UP = + key on the left side of the device
• Vol_DN = - key on the left side of the device

Firmware Loading Instructions

MCU Firmware (required for upgrading from Version 1.02 to Version 1.09 or later)

• Download the latest MCU firmware file from the software section of this page.
• Extract tMcuFU.exe to the root of a micro sd card, and place the Micro SD card into the H22.
• Press and hold the "volume down" key and the "right scan" key then turn the H21 on (continue holding both keys).
• If the sw update does not start press the reset button while hodling "left scan" + "right scan" + "volume down"
• wait for the sw update to finish

SD card method for loading firmware

• Download the latest firmware file from the software section of this page.
• Extract the firmware file to the root of a micro sd card, and place the Micro SD card into the H22.
• Press and hold the "volume down" key and the "right scan" key then turn the H21 on (continue holding both keys).
• If the sw update does not start press the reset button while hodling "left scan" + "right scan" + "volume down"
• wait for the sw update to finish and proceed with the setup wizard

PC connection for loading firmware

• Connect the H22 to a PC running Windows XP or Windows 7.
• Install Microsoft Active sync/ Windows Mobile Device Center.
• Download the latest RUU_xxxx.exe firmware loader file from the software section of this page.
• Run RUU_xxxx.exe on the PC and follow the instructions

Downloads

Documents

Software