CRD3301

Revision as of 19 October 2017 16:00 by JGoss (Comments | Contribs) | (DIP SWITCHES)

About

The CRD3301 is a charging and communication cradle for the OPR3301, OPI3301, and OPI-3301i .

Note

The cradle must be rebooted before new dip switch settings can take effect.

DIP SWITCHES

The following functions can be set with DIPSW on the bottom of this unit:

  • DIPSW 2: No security, inquiry scan enabled.
You will be able to connect without authentication.
  • DIPSW 3: Invalidate the connection protocol.
It will be able to connect with Bluetooth devices other than OPR - 3101.
  • DIPSW 4: Disables detection of the DTR signal of the host.
Set when there is no DTR signal on the host side equipment.
  • DIPSW 5: Set to the initial state (shipping setting).
The contents of FLASH are returned to the initial state.
  • DIPSW 6: Please use it normally OFF.
In the ON state, the unit enters a download mode (software rewrite mode is set). Software can be changed using the RS - 232C interface.
  • All DIP-SWITCHES are read at power-on. If any are changed, the unit must power-cycle.