| |
|
+ |
The technical information about the OK and NG (no good) signals for the NLB-1000 and the NVL-1001 can be found on this page
|
| |
|
+ |
1.1 OK/NG sequencer test results for the NLB-1000 (motor on when idle)
|
| |
|
+ |
1.2 OK/NG sequencer test results for the NLV-1001 (motor on when idle)
|
| |
|
+ |
2 OK NG sginal menu options
|
| |
|
+ |
OK/NG sequencer test results for the NLB-1000 (motor on when idle)
|
| |
|
+ |
Note 1: The trigger-to-decode time of 2,6 to 3,8 ms when the motor is ON when idle is respectively 250ms – 275ms when the motor is OFF when idle
|
| |
|
+ |
Note 2: To test the performance, always present a barcode of high quality at a fixed distance. Before starting the test, make sure that the barcode is read 1000 times per second by performing a read test in the laser adjustment mode.
|
| |
|
+ |
OK/NG sequencer test results for the NLV-1001 (motor on when idle)
|
| |
|
+ |
Note 1: The trigger-to-decode time of 45 to 64 ms when the motor is ON when idle is respectively 91ms – 95ms when the motor is OFF when idle
|
| |
|
+ |
Note 2: To test the performance, always present a barcode of high quality at a fixed distance. Before starting the test, make sure that the barcode is read 100 times per second by performing a read test in the laser adjustment mode.
|
| |
|
+ |
OK NG sginal menu options
|
| |
|
+ |
Use this menu code sheet to adjust the settings on the scanner
|
| |
|
+ |
File:OK_NG_signal_menu_options.JPG Interface OK/NG signals
|
