Version Differences for OPH3001 - Opticon Technical Support Portal

===Download Files===

You will need a few files to update your OPH3001. All of these files can be found in the Downloads table below.

-

* USB Cradle Drivers (necessary only if you are using the USB cable for the cradle)

+

* USB Drivers

* Firmware: OS

* Firmware: Application

-

===Set Up Your Cradle===

-

A cradle is required to load firmware onto your OPH3001. More information about the [[CRD1001]] cradle can be found [[CRD1001|here]]. If you are using USB drivers install them now. Do not connect the cradle to the computer via USB until these drivers are installed. If the cradle was already plugged in simply disconnect and reconnect it. Power must be connected to the cradle at all times (even with a USB connection).

===Install and Configure Appload===

Appload is a PC application that is used to load firmware on most of Opticon's devices. Once it is installed (by running the installer found in the Downloads table at the bottom of the page) it will launch automatically. Change the options 'Settings' > 'Port' to match the COM port of either the USB or RS232 interface (whichever was used, do not connect both). Change 'Settings' > 'IrDA Adapter/cradle type' to be 'Not Installed'.

 ===Download Files===
 You will need a few files to update your OPH3001. All of these files can be found in the Downloads table below.
-								* USB Cradle Drivers (necessary only if you are using the USB cable for the cradle)
+								* USB Drivers
 * Firmware: OS
 * Firmware: Application
-								===Set Up Your Cradle===
-								A cradle is required to load firmware onto your OPH3001. More information about the [[CRD1001]] cradle can be found [[CRD1001|here]]. If you are using USB drivers install them now. Do not connect the cradle to the computer via USB until these drivers are installed. If the cradle was already plugged in simply disconnect and reconnect it. Power must be connected to the cradle at all times (even with a USB connection).
 ===Install and Configure Appload===
 Appload is a PC application that is used to load firmware on most of Opticon's devices. Once it is installed (by running the installer found in the Downloads table at the bottom of the page) it will launch automatically. Change the options 'Settings' > 'Port' to match the COM port of either the USB or RS232 interface (whichever was used, do not connect both). Change 'Settings' > 'IrDA Adapter/cradle type' to be 'Not Installed'.