Version Differences for OPH3001
|
(→Software)
|
(→Set Up Your OPH3001)
|
| Line 14: | |||
| Appload is a PC application that is used to load firmware on most of Opticon's devices. Once it is installed (by running the installer found in the Downloads table at the bottom of the page) it will launch automatically. Change the options 'Settings' > 'Port' to match the COM port of either the USB or RS232 interface (whichever was used, do not connect both). Change 'Settings' > 'IrDA Adapter/cradle type' to be 'Not Installed'. | Appload is a PC application that is used to load firmware on most of Opticon's devices. Once it is installed (by running the installer found in the Downloads table at the bottom of the page) it will launch automatically. Change the options 'Settings' > 'Port' to match the COM port of either the USB or RS232 interface (whichever was used, do not connect both). Change 'Settings' > 'IrDA Adapter/cradle type' to be 'Not Installed'. | ||
| ===Set Up Your OPH3001=== | ===Set Up Your OPH3001=== | ||
| - | The OPH3000 must be placed into a download mode for firmware to install correctly. To do this follow the steps below. | + | The OPH3001 must be placed into a download mode for firmware to install correctly. To do this follow the steps below. |
| * Press [Fn1] + [BS] | * Press [Fn1] + [BS] | ||