Version Differences for OPH3000 - Opticon Technical Support Portal

* Firmware: Application

* Appload

-

===Set Up Your Cradle===

+

===Install Drivers===

-

A cradle is required to load firmware onto your OPH3000. More information about the [[CRD1001]] cradle can be found [[CRD1001|here]]. If you are using USB drivers install them now. Do not connect the cradle to the computer via USB until these drivers are installed. If the cradle was already plugged in simply disconnect and reconnect it. Power must be connected to the cradle at all times (even with a USB connection).

+

To connect your OPH3000 to the computer, you must first install the USB drivers. The USB Drivers are available as part of the All In One PC drivers, available in the [[#Drivers|Drivers Downloads]] section.

===Install and Configure Appload===

Appload is a PC application that is used to load firmware on most of Opticon's devices. Once it is installed (by running the installer found in the Downloads table at the bottom of the page) it will launch automatically. Change the options 'Settings' > 'Port' to match the COM port of either the USB or RS232 interface (whichever was used, do not connect both). Change 'Settings' > 'IrDA Adapter/cradle type' to be 'Not Installed'.

 * Firmware: Application
 * Appload
-								===Set Up Your Cradle===
+								===Install Drivers===
-								A cradle is required to load firmware onto your OPH3000. More information about the [[CRD1001]] cradle can be found [[CRD1001|here]]. If you are using USB drivers install them now. Do not connect the cradle to the computer via USB until these drivers are installed. If the cradle was already plugged in simply disconnect and reconnect it. Power must be connected to the cradle at all times (even with a USB connection).
+								To connect your OPH3000 to the computer, you must first install the USB drivers. The USB Drivers are available as part of the All In One PC drivers, available in the [[#Drivers|Drivers Downloads]] section.
 ===Install and Configure Appload===
 Appload is a PC application that is used to load firmware on most of Opticon's devices. Once it is installed (by running the installer found in the Downloads table at the bottom of the page) it will launch automatically. Change the options 'Settings' > 'Port' to match the COM port of either the USB or RS232 interface (whichever was used, do not connect both). Change 'Settings' > 'IrDA Adapter/cradle type' to be 'Not Installed'.