| |
*[http://ftp.opticon.com/H16_H19/SDK%20-%20EGG32880/ H16 SDK Download Page] |
|
*[http://ftp.opticon.com/H16_H19/SDK%20-%20EGG32880/ H16 SDK Download Page] |
| |
|
+ |
Menu Codes is the term Opticon uses to indicate a barcode or number/letter combination that has special significance to our barcode scanners. Nearly all of Opticon's products use the same set of menu codes for all possible configuration options. In the case of the H16, many of these options are expressed as buttons and drop down boxes on the various tabs of the Scanner Settings program as described above. A few options, notably those categorized as ''Data Wizard'' options must still be configured manually. These menu codes, when known, are placed in the flat text file Initbcr.bcr as described above. The ''Data Wizard'' is a series of Menu Codes that allow for basic string manipulations such as removing or replacing certain characters within the barcode data or only transmitting certain portions based on matching criteria. Please [mailto:support@opticonusa.com Contact Us] for additional details on these features. A specific example of these codes (used to remove a possible 18th digit from a normally 17 digit VIN) and instruction in their use can be found below.
|
| |
|
+ |
=====How do I strip out the 18th digit from Vehicle Identification Numbers (VINs)=====
|
| |
|
+ |
#Navigate to '''Start''' > '''Settings''' > '''System''' (tab) > '''Barcode Settings''' > '''Menu codes''' (tab).
|
| |
|
+ |
#Tap 'Set Defaults' then 'yes' when prompted.
|
| |
|
+ |
#You will receive the message "Transmit Command Success'. Tap 'ok'.
|
| |
|
+ |
#Enable the Barcode Reader
|
| |
|
+ |
#*Tap the 'Options' tab at the bottom of the screen.
|
| |
|
+ |
#*Check the box that says 'Barcode reader: ? Enabled.
|
| |
|
+ |
#*Tap OK in the top right hand corner of the screen.
|
| |
|
+ |
#*Return to 'Barcode Settings' > 'Menu codes' (tab).
|
| |
|
+ |
#Tap 'View' at the bottom left of the screen and then tap 'Wrap to Window' so that the check mark is removed.
|
| |
|
+ |
#the text "RZ1M" is present by default. Go to a new line and type the following exactly as you see it here:<pre>[A00[A0W[A0ZQ1Q8[A12Q0Q00I[A14Q0Q1[A1CQ0Q0[A1L[A18[A1F
|
| |
|
+ |
[A01[A0W[A0ZQ1Q8[A12Q1Q70B[A14Q0Q0[A1CQ0Q1[A1L[A18[A1F</pre>
|
| |
|
+ |
#Tap 'ok' to save the text file
|
| |
|
+ |
#Tap 'x' to close Word Mobile.
|
| |
|
+ |
#Tap the button 'Update'. Select 'Yes' when you are prompted.
|
| |
|
+ |
#You should now again see the message 'Transmit Command Success'.
|
| |
|
+ |
#Tap 'ok' to close the message.
|
| |
|
+ |
#Tap 'ok' to close the Barcode Scanner Settings.
|
| |
|
+ |
#Tap 'x' to close the Settings window.
|
