| |
5. Select 'Update' to send the new command to the MDI. You should a message acknowledging that the command was successful.<br> |
|
5. Select 'Update' to send the new command to the MDI. You should a message acknowledging that the command was successful.<br> |
| |
|
+ |
A factory reset can be performed that will reload Windows Mobile into a 'Vanilla' state. This will require that all data and customer applications are reinstalled after the factory reset is complete. There are two ways to perform a factory reset.
|
| |
|
+ |
:*Navigate to 'Start' > 'Settings' > 'System' (tab) > 'Factory Reset' (icon)
|
| |
|
+ |
:*Type '1234' as instructed by the on screen directions.
|
| |
|
+ |
::'''Note''': This process will only delete User Store and will not touch DiskOnChip.
|
| |
|
+ |
:*Using the standard stylus press and release the reset switch on the left side of the unit.
|
| |
|
+ |
:*Press the power switch or connect the device to external power. It will begin to boot.
|
| |
|
+ |
:*Before the Opticon Logo screen appears begin holding the power button.
|
| |
|
+ |
:*After a few seconds a blue screen will appear with the following options:
|
| |
|
+ |
1 Left Key to Format User Store
|
| |
|
+ |
2 Right Key to Format DiskOnChip
|
| |
|
+ |
3 Up Key to Format User Store and DiskOnChip
|
| |
|
+ |
:*You have 5 seconds to make a selection. The keys it refers to are the direction keys on the face of the device between the Windows flag button and the OK button.
|
| |
|
+ |
::'''Note''': These keys can be difficult to press correctly when hurried.
|
| |
|
+ |
:*The next blue screen will be a confirmation of your selection. Use the left or right soft keys (just below the display) to choose 'Yes' or 'Cancel'.
|
| |
|
+ |
:*The Opticon Logo screen will appear and the device will continue to boot. It will take longer this time than normal and when complete you will see the Windows Mobile initial setup screen.
|
