| |
===Restore Default Settings=== |
|
===Restore Default Settings=== |
| |
|
+ |
* 1) Hold the MODE button AND the Trigger button down while you power up the scanner. Keep holding until you see all LEDS flashing, then release. The unit will continue for some time to reboot, but it will be set to the original factory defaults. Any past configurations that were saved in memory will still be there to recall.
|
| |
|
+ |
* 2) Open the CONSOLE web page. Click on the Options GEAR icon in the upper-right corner. Select "Restore Factory Defaults".
|
| |
|
+ |
** Restoring factory defaults will set the IP address/Port back to:
|
| |
|
+ |
*** ETHERNET: 192.168.2.220 PORT: 8080
|
| |
|
+ |
*** USB-NET: 192.168.2.221 PORT: 8080
|
| |
|
+ |
*** Web Server [CONSOLE] = PORT: 8080
|
| |
|
+ |
*** Telenet Service = PORT: 23
|
| |
===Configure the Scanner=== |
|
===Configure the Scanner=== |
| |
The output of this barcode reader can be modified in several different manners. Using several different tools. The following tools are available for you to use in configuring your scanner. Please submit a ticket above for assistance from Opticon's Technical Support Team. |
|
The output of this barcode reader can be modified in several different manners. Using several different tools. The following tools are available for you to use in configuring your scanner. Please submit a ticket above for assistance from Opticon's Technical Support Team. |
