Version Differences for CRD3301

(→About)

(→Note)

 ==Note==
 The cradle must be rebooted before new dip switch settings can take effect.
 								==DIP SWITCHES==
 								Setting of DIPSW
 								The following functions can be set with DIPSW on the bottom of this unit.
 								DIPSW 1: Always be sure to turn OFF.
 								It is for future function expansion.
 								DIPSW 2: No security, inquiry scan enabled.
 								You will be able to connect without authentication.
 								DIPSW 3: Invalidate the connection protocol.
 								It will be able to connect with Bluetooth devices other than OPR - 3101.
 								DIPSW 4: Disables detection of the DTR signal of the host.
 								Set when there is no DTR signal on the host side equipment.
 								DIPSW 5: Set to the initial state (shipping setting).
 								The contents of FLASH are returned to the initial state.
 								DIPSW 6: Please use it normally OFF.
 								In the ON state, software rewrite mode is set.
 								Software can be changed using the RS - 232C interface.
 								? All DIPSW is effective when the power is ON.
 								? The shipping setting is SW 6 ON, the rest are OFF.